MX12: Inox Supa Glide W/ Ptfe

$19.95

6 oz Aerosol…..19.95

Clear
SKU: N/A Categories: ,

Description

INOX-MX12 PTFE Supa Glide is a fast drying, resin bonded polytetrafluoroethylene dry film lubricant for the coating of timber, metal, plastic, rubber, glass and most other surfaces.

INOX-MX11 Chain & Brake Clean is a good degreaser for cleaning all metals, glass and some plastics. It dries very quickly and leaves no residue.

It is designed for low-friction, light load repetitive stresses that allows moving parts to wear longer, work harder and require less maintenance.

Has applications where other conventional PTFE coatings cannot be considered; therefore a must for Tampa Bay Yacht Masters to distribute completing the entire INOX lubrication line of products.

Features

Excellent lubrication qualities
Good surface adhesion
Hard abrasion-resistant surface
Clean and easy to apply
Thin film
Longer wear life than pure PTFE coatings
Cures at room temperature
Inhibits corrosion
Doesn’t wash off with water
Resists contamination from dirt and dust
Life-long lubrication in many household, auto, marine, manufacturing/commercial, industrial hobby, applications


Surface Preparation

Before applying INOX-MX12 PTFE Supa Glide, the surfaces should be clean, dry and free of contaminants such as oil, grease, dust or powder. A light sanding with 120 grit sandpaper or emery cloth followed by a solvent wipe and air dry is usually sufficent.

More critical applications requiring optimum adhesion, the following pretreatments are suggested:
WOOD- Sand lightly and wipe clean
STEEL- Degrease or sandblast
STAINLESS STEEL- Degrease or sandblast
ALUMINIUM- Degrease, sandblast or anodize
COPPER ALLOYS- Degrease, sandblast and/or acid etch
RUBBER, PLASTIC & GLASS- Clean with a solvent that will not effect the substrate


CAUTION: DO NOT USE TO CLEAN RUBBER PRODUCTS.

INOX-MX12 PTFE Supa Glide is recommended for:
• Sliding door, window and curtain tracks
• Sailtracks
• Garage/factory roller door tracks
• Truck/trailer side curtain tracks
• Moving furniture parts
• Piano action parts
• Flexible inner cables
• Solenoid plungers
• PTO couplings
• Pulleys & open gears
• Winches and cables
• Metal, plastic and neoprene bushes
• Saws & guillotines
• Metal punching/stamping machines
• Looms
• Work surfaces for work tables/sewing machines
• And any other sliding or turning surfaces that require a high grade, hard wearing dry lubricant.

Curing Time
INOX-MX12 PTFE Supa Glide will cure at room temperature. Coatings are touch dry in about 5 minutes and dry enough to handle in 20 to 30 minutes depending on the film thickness. Optimum hardness for the best lubrication operation is 2 hours. It is strongly advised to allow 2 hours from application to use for the best long term results. High humidity may increase opacity or blush and exposure to strong sunlight may cause darkening, but these will not effect the coating performance.

IMPORTANT NOTICE: INOX-mx12 APPLICATIONS MUST BE FULLY CURED (APPROX 2 HRS) BEFORE THEY CAN BE USED. IF IS NOT CURED PROPERLY THE COATING MAY RUB OFF OR STICK TO ANOTHER SURFACE PREMATURELY

Additional information

Weight N/A
Dimensions N/A
Size (MX12)